Lenz DCC Support and Discussion - The Whistle Post

TallDude · #1 (**permalink**) 12-07-2008, 05:33 PM

This sub-forum is to discuss the Lenz family of DCC systems.

Information on the Lenz DCC systems can be found here:

Digital Plus by Lenz

hutchhutchinson · #2 (**permalink**) 07-04-2009, 08:40 PM

Hi Guys
I am having a bit of a problem were do you find the place to write a new thread post? as I would like to start one,
I cannot find the icon to start.
Cheers,
Hutch.

TallDude · #3 (**permalink**) 07-04-2009, 09:31 PM

For this particular forum, if you go here

Lenz DCC Support - The Whistle Post - Model Railroad Forum

there should be a New Thread button towards the upper left side.

You can start a new thread on any forum by going here:

The Whistle Post - Model Railroad Forum - Powered by vBulletin

then clicking on a forum and doing the same as above.

Hope that helps

hutchhutchinson · #4 (**permalink**) 07-04-2009, 11:18 PM

Hi
Thank you I have found it
cheers,
Hutch.

thogan3 · #5 (**permalink**) 11-01-2009, 07:23 AM

I have an older Atlas/Kato HO F3. with the olderer light board, which made putting the decoder in easier! I installed a Lenz L103 decoder in it and all is fine, 'cept the headlight flickers while running, but the loco runs smooth as silk! All my other installs, the headlights are on, no flicker. The solder is strong, wheels clean, can't figure this out?

domiluk · #6 (**permalink**) 11-01-2009, 08:54 AM

Sound like the decoder and your cammand station are not on the same page i mean decoder is on 28 speed and cammand is on 128 speed check is out.

thogan3 · #7 (**permalink**) 11-01-2009, 10:00 AM

I use decoder pro from my pc, yes all on 128, thanks